3d-robotics X8 Plus Manuel d'utilisateur télécharger pdf (Page 33)

Initiating

Stabalize

Altitude Hold

Loiter

Full Autonomy

Return to Launch

Stabalize

Altitude Hold

Loiter

Full Autonomy

Return to Launch

Left Stick

For auto-takeoff, raise

throttle to start mission.

Once you’ve saved the mission to the X8, follow these steps to ﬂy the mission.

1 Perform a pre-mission test ﬂight.

Follow the standard takeoff procedure, and ﬂy a

brief test flight to verify that all controls (throttle,

yaw, roll, and pitch) are responding normally.

2 Arm in standard mode.

When you’re ready to start the mission,

arm the X8 in standard (STD) mode.

3 Switch to auto mode.

For automatic takeoff, arm the X8 in standard

mode. Then switch to auto mode, and raise the

throttle to initiate the mission.

For manual takeoff, initiate the mission in ﬂight by

switching to auto mode.

Controller: mode switch Controller: mode switch Controller: left stick

Automatic Landing

For missions conﬁgured with a land

waypoint, the X8 will disarm automatically

after landing. Ensure that the throttle

stick is set fully down during landing; the

X8 will not disarm automatically unless

the throttle stick is set fully down.

Manual Landing

For missions without a land waypoint,

switch to standard or loiter mode in ﬂight

then land manually.

Ending

To avoid sudden changes

in altitude when switching

from auto mode to standard

mode, ensure that the left

stick is set to the center

position.

End the mission according to the type of

landing conﬁgured in the mission.

1 2 ... 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

3d-robotics X8 Plus Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement aérien 3d-robotics X8 Plus