3d-robotics X8 Plus Manuel d'utilisateur télécharger pdf (Page 20)

Auto mode

AUTO

fly a mission

Select auto mode to fly an autonomous mission. The X8 will

automatically fly the series of waypoints saved to the autopilot.

See the Missions section on page 28 for instructions on planning and flying missions.

Stabalize

Altitude Hold

Loiter

Full Autonomy

Return to Launch

Gimbal control

TILT

tilt the camera up and down

Connect a Tarot Gimbal (sold separately), and use the TILT knob to control the

angle of the camera in flight. Visit 3DR.com/X8/info for instructions.

Stabalize

Altitude Hold

Loiter

Full Autonomy

Return to Launch

Land

CH 7

land at the current position

Set the CH 7 switch to ON to end your flight and land at the current position.

Once you activate land, set the throttle stick fully down, and the X8 will auto-

matically disarm after landing. The X8 will not disarm automatically unless the

throttle stick is set fully down.

Reposition during landing: During landing, use the right

stick on the controller to adjust the X8’s position.

Do not activate auto mode unless you have saved

a mission to the X8 using a ground station application.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Pas de commentaire

3d-robotics X8 Plus Manuel d'utilisateur Page 20