3d-robotics X8 Plus Manuel d'utilisateur télécharger pdf (Page 34)

Appendix: Troubleshooting

Maintenance

Pre-Arm Safety Check Failure

If the status LED displays blinking yellow, the X8 is failing one the pre-arm safety checks. To determine the speciﬁc failure, check the

heads-up display on the ground station. There will be an error message specifying the failed check.

Radio Calibration Failure: Perform Radio Calibration or RC controller re-binding

Accelerometer Calibration Failure: Perform Accelerometer Calibration

Compass Calibration Failure: Perform Compass Calibration

GPS Failure: Wait for improved GPS signal or move to a more open area

Video tutorials for performing calibrations can be found at 3DR.com/X8/info.

Replacement parts for the X8 can be purchased at store.3DR.com.

Instructions for replacing the wiring, plates, motors, and legs of the X8 can be

found at 3DR.com/X8/info.

1 2 ... 29 30 31 32 33 34 35 36

Pas de commentaire

3d-robotics X8 Plus Manuel d'utilisateur Page 34