3d-robotics X8 Plus Manuel d'utilisateur télécharger pdf (Page 21)

land at the launch point

Set the RTL switch to ON to end your flight and return the X8 to

the launch point automatically. Once you activate RTL, set the

throttle stick fully down, and the X8 will automatically disarm after

landing. The X8 will not disarm automatically unless the throttle

stick is set fully down. Ensure that the RTL switch is set to OFF

before takeoff.

When commanded to RTL, the X8 will:

1 Achieve minimum altitude of 15 m (50 ft) or maintain current altitude if

above 15 m.

2 Move to launch point and loiter for 5 seconds.

3 Land at launch point. Wait a few seconds and disarm automatically.

launch point

15 meters1

hover 5 seconds

Stabalize

Altitude Hold

Loiter

Full Autonomy

Return to Launch

Reposition during landing: During landing, use the right

stick on the controller to adjust the X8’s position.

RTL returns the X8 to the location where it was armed.

Always arm the X8 at a safe, unobstructed launch point.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Pas de commentaire

3d-robotics X8 Plus Manuel d'utilisateur Page 21