3d-robotics Tarot gimbal Manuel d'utilisateur télécharger pdf (Page 2)

2 Attach camera

Your Tarot gimbal is compatible with a GoPro HERO3, available from store.3dr.com.

Remove the two screws securing the blue face plate.

Remove the plate, and loosen the set screw.

face plate

remove

Slide camera into housing with the lens nearest

the top-right corner.

assembled leg

Add the nut to the bolt, and tighten to secure the leg to the arm.

Attach all four tall legs to IRIS.

Optional: To remove the short legs, use

the small hex key (1.5 mm) to remove the

screw in the bottom of the leg, and slide

the leg out of the arm.

Important note: Make sure that the WiFi on your GoPro is

turned OFF at all times when in use with IRIS.

remove

loosen

1 2 3 4 5

Pas de commentaire

3d-robotics Tarot gimbal Manuel d'utilisateur Page 2