3d-robotics Remzibi’s OSD 3DR Manuel d'utilisateur

Remzibi’s OSD 3DR (with DIY Drones version firmware) This tutorial is intended to be used with Happy Killmore’s manual (link). This tutorial will cove

Connecting your Remzibi’s OSD 3DR to your computer The Remzibi’s OSD 3DR is connected to your computer using the DIY Drones Remzibi’s OSD cable. Black

switch the mode. When the board is in programming mode, the blue LED will be solid. If the Remzibi’s OSD 3DR board’s video output is hooked up to

Testing the Serial Connection Connect your Remzibi’s OSD 3DR to your computer (see the “Connecting your Remzibi’s OSD 3DR to your computer” secti

Updating Firmware Your Remzibi’s OSD 3DR comes with the latest DIY Drones version of the firmware, and character set already loaded. We recommend usi

This concludes the Remzibi’s OSD 3DR tutorial. Thank you for reading! Please send any feedback regarding this tutorial to Carmen at [email protected]

 Video Camera and transmitter/receiver check out rcgroups.com for more information on video transmitters and receivers, and to learn more about FPV

Important Revision Note: The release version of the Remzibi’s OSD 3DR, has an error on the silk screen label on the back side of the board: the si

Here I have all of the pins cut and set next to the pads I will be soldering them to on the Remzibi board: Carefully solder the pins onto the board.

Soldering a Connector for Your Battery If you’re using a connector for your battery that is not compatible with the connector that comes with the Remz

This concludes the Assembly portion of the tutorial! Next: How to flash your DIY Drones Mediatek GPS with the factory firmware! Female Connec

DIY Drones Mediatek GPS The DIY Drones Mediatek GPS comes with custom DIY Drones firmware for use with the ArduPilot Mega system. To use the Media

Uploading the Firmware Download the firmware update utility found here and unzip the file. Download the factory default firmware found

Powering the Board Remzibi’s OSD 3DR must be powered externally with 12V. To power your board, just plug your 12V battery into the P