3d-robotics Digital Airspeed Sensor Manuel d'utilisateur télécharger pdf

PIXHAWK DIGITAL AIRSPEED SENSOR

Digital airspeed sensor

Pitot tube Rubber tubing

Assemble

Four-wire I

C cable

Connect the four-wire cable to the four-position port on the airspeed sensor.

Cut the piece of rubber tubing in half. You should have two pieces of equal length.

Attach a piece to each of the input sensor cones on the board.

Connect the tube attached to the cone on the top of the board to the longer

extension on the pitot tube, and connect the tube attached to the cone on the

main, lower section of the board to the smaller extention on the pitot tube.

pitot tube

complete assembly

sensor cones

1 2 3

Résumé du contenu

Page 1 - Assemble

PIXHAWK DIGITAL AIRSPEED SENSORDigital airspeed sensorPitot tube Rubber tubingAssembleFour-wire I2C cableConnect the four-wire cable to the four-posit

Page 2 - Connect to Pixhawk

Connect to PixhawkConnect the four-wire cable to Pixhawk’s I2C port or I2C splitter.Pixhawk I2C splitterMountMount the pitot tube parellel to the fuse

Page 3 - Speciﬁcations

ConﬁgurationTo enable the airspeed sensor, connect Pixhawk to Mission Planner (or APM Planner for OS X), and select the Advanced Parameter List under

Commentaires sur ces manuels

Pas de commentaire

3d-robotics Digital Airspeed Sensor Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs 3d-robotics Digital Airspeed Sensor. 3D Robotics Digital Airspeed Sensor User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels